What are the precautions for the first installation of the pneumatic motor? Next, there are pneumatic motor manufacturers to introduce to you, I hope that our introduction can help you better.

The pneumatic motor is a kind of more precise power machine, and it is strictly prohibited to knock and disassemble when it is installed. It does not bear the axial force. Please install the pneumatic motor under the requirements of the use of the pneumatic motor. In the receiving tube, should be compressed air open, remove dust and debris inside the tube using the gas pressure to ensure clean air. The inner diameter of the trachea must be greater than or equal to the diameter of the air inlet of the gas motor, in order to ensure the supply of gas. It is necessary to add lubricating oil (20# oil) to the oil mist in time to ensure the lubrication of the gas motor. The coaxiality of the output shaft of the pneumatic motor and the input shaft of the drive animal (host) should be guaranteed. The design personnel of the host should make safe operation regulations according to the characteristics of the pneumatic motor so as to ensure the safe operation of the whole machine. Install emergency stop device in a convenient position in case of emergency. When installing, maintenance and maintenance, we must close the valve and cut off the gas source so that it can work. It is not allowed to run continuously and high speed pneumatic motor under no load condition (if it is necessary, it is best not to exceed half a minute), otherwise it will reduce or damage the life of the pneumatic motor. Gas leakage is not allowed in the gas supply line and the interface of the pneumatic components to ensure the gas supply quality of the pneumatic motor. The exhaust of the air motor can be matched with the muffler, but not completely blocked, or affect the operation of pneumatic motor. Bidirectional rotating air motor, one inlet inlet, another air inlet becomes negative air outlet, must not be blocked, it is best to use three or four valves, pneumatic motor can not operate normally. The pneumatic motor should be maintained and cleaned regularly, and the vulnerable parts should be replaced. To ensure the normal operation of the pneumatic motor. A pneumatic motor that has not been used for a long time can pour a little lubricating oil (No. 20 machine oil) from the air inlet to the output shaft by hand, then connect the compressed air, and make the internal cleaning of the motor automatically in a dynamic way (30 seconds). The gas - pneumatic motor can be repeated, feeling the pneumatic motor is operating normally and then installed.

Are you aware of the initial installation of pneumatic motor by pneumatic motor manufacturers? If you want to learn more, please continue to pay attention to us.